Creative Mark Chamois Skin 
QuickFix Battery Powered Art Eraser 
Iwata Eclipse Takumi Side Feed Dual Action Airbrush 
Iwata Custom Micron Takumi Side Feed Dual Action Airbrush 
Studio Designs Hourglass Craft Center 
KUM Metal Long Point Pencil Sharpener 
Winsor and Newton Permanent Masking Fluid 75 ml (2.5 OZ) 
Iwata NEO AIR Compressor 
Fundamentals Kids Easel Paper Roll 
Winsor and Newton Artisan Stand Oil 75 ml (2.5 OZ) 
Prismacolor Design Art Gum Eraser 
Saint Remy Multi-Angle Wood Studio Easel 
Daylight UnoLamp Floor 
BEST The Crank Easel 
Description
What it does
- Breaks water tension to improve flow and lower viscosity
- Gives a smooth finish with less brush strokes due to reduced surface friction
- Increases transparency and makes color more absorbent and blendable
How to use it
- Fully intermixable with all Liquitex products
- First dilute your concentrated Flow Aid with water ‚ 1 part Flow Aid to 20 parts water ‚Äì distilled water will give the best results. Use 1 part Flow Aid to 10 parts water if you want a more concentrated effect
- Add up to 25% of diluted Flow Aid to your color/medium and stir slowly to avoid foaming. If it does foam, leave it to sit while the foam disappears
- If applying to an absorbent surface, your color/medium will sink in like a stain or dye; if using on a non-absorbent surface your color/medium will be more fluid and take longer to dry
How not to use it
- Do not use Flow Aid undiluted as it results in poor acrylic adhesion, cracking, tackiness and water sensitivity
- As this is an additive ‚ with no acrylic binders do not add more than 25% to your color/medium and do not mix with other additives. This can cause excessive shrinkage, cracking and the acrylic film to break down
- Do not shake or stir too vigorously as foam will form
- Don‚t use for marbling as it breaks the surface tension of the water
- Do not use with any non-acrylic media
